MURO CH7260 User Manual download pdf (Page 4)

Ver: 10/14/2004 4

Removal of strips from Tool

1) Move the feed lever over slightly, and then press on the end of the feed latch as in

photo 3.

2) Move the feed lever back so it no longer centers the fastener as in Photo 4 and

release the feed latch. This frees the screw from the feed latch.

3) Then, pull the strip towards you and then out of the tool as shown in Photo 5. This

action will push over the strip tensioner spring to allow the strip to be removed easily.

It should be noted that

fasteners with large

heads

might not

directly latch into the

screw guide easily. If

this happens, push the

feed lever over with

your finger while

inserting the strip of

screws to latch the

first screw before

using.

1 2 3 4 5 6 7 8 9 ... 12 13

No comments

MURO CH7260 User Manual Page 4