MURO CH7260 User Manual download pdf (Page 3)

Ver: 10/14/2004 3

Maintenance and Inspection of CH7260

For best results keep your CH7260 Metal Pro Clean and Free of dirt and debris for

smooth operation. Inspect and Blow out or vacuum it after use. Built up dust and dirt may

cause tool wear. To clean the tool, use a damp cloth or soap and water damped cloth, do not

use thinners or gasoline or other solvents that would damage the unit, or fully immerse it in

water, which may cause rusting. Bits are consumable and must be replaced if worn, bits are

specially designed for the Muro auto feed system.

Loading Screws in the CH7260 Metal Pro

Ensure that screws are loaded into the CH7260 with the Plastic strip facing

outwards per the diagram on the side of the screwdriver. The strips must be inserted as

shown to work properly i.e. only one way works, if inserted backwards, they will jam.

Generally, the correct end of the strip will be longer. Check that the free end of the strip fits

into the strip guide, Latch (hook) the first screw with the feed latch (Photo 2).

The strip guide supports the screw strip, assisting in keeping the screws in the correct

position for pick up by the bit, particularly for the last screws to be driven. The strip spring

acts to keep tension and a ratchet on the screw strip, also keeping the screws in the correct

position.

The strips must be

inserted as shown to

work properly i.e.

only one way works,

if inserted backwards,

they will jam. Latch

in the first screw.

1 2 3 4 5 6 7 8 ... 12 13

No comments

MURO CH7260 User Manual Page 3